Lincoln vs Cadillac - Do It Yourself Car Repair   Cadillac
Lincoln vs Cadillac Forums - - - LVC Tech Articles Home

 
 

Replacing the Spark Plugs in the V8 Lincoln LS

   

Lincoln LS

Submitted by: Quik LS

Replacing spark plugs on the V8 is easy to do but requires working in a tight space, while the V6 is a little more involved as it requires the removal of the intake (which is listed in a seperate tech article).

While you have access to this area, examine the coils to ensure they do not need to be replaced at the same time.

 

Spark Plug

Removal

1.       Remove the ignition coil.
2.       NOTE: Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.
Remove the spark plugs.

3.       Inspect for a bridged gap.
· Check for deposit build-up closing the gap between electrodes. Deposits are caused by oil or carbon fouling.

· Clean the spark plug.

4.       Inspect for oil fouling, identified by wet, black deposits on the insulator shell bore electrodes. This is caused by excessive oil entering the combustion chamber through worn rings and pistons, excessive valve-to-guide clearance or worn or loose bearings.
· Correct the oil leak concern.
· Install a new spark plug.

5.       Inspect for carbon fouling, identified by black, dry, fluffy carbon deposits on the insulator tips, exposed shell surfaces and electrodes. This is caused by a spark plug with an incorrect heat range, dirty air cleaner, too rich a fuel mixture or excessive idling

· Clean the spark plug.

6.       Inspect for normal burning.

· Check for light tan or gray deposits on the firing tip.

7.       Inspect for pre-ignition, identified by melted electrodes and possibly a damaged insulator. Metallic deposits on the insulator indicate engine damage. Pre-ignition may be caused by incorrect ignition timing, wrong type of fuel or the installation of a heli-coil insert in place of the spark plug threads.

· Install a new spark plug.

8.       Inspect for overheating, identified by a white or light gray insulator with small black or gray-brown spots with bluish-burnt appearance of electrodes. This is caused by engine overheating, wrong type of fuel, loose spark plugs, spark plugs with an incorrect heat range, low fuel pump pressure or incorrect ignition timing.

· Install a new spark plug.

9.       Inspect for fused spot deposits, identified by melted or spotty deposits resembling bubbles or blisters. This is caused by sudden acceleration.

· Clean the spark plug.

10.   Inspect to make sure the platinum tip is present.


11.   Adjust the spark plug gap as necessary.

Installation

1.       To install, reverse the removal procedure.


This area is intended for Tech Tips submitted by members of LincolnvsCadillac.com. The opinions expressed here are the opinions of the individual author and do not necessarily represent the views of LincolnvsCadillac.com. Undertake these procedures at your own risk. If you have any comments or questions please contact the individual authors. Reader assumes all the risk associated with the installation of aftermarket products. LincolnvsCadillac.com and its owners are not responsible for any direct or indirect damage to the vehicle, person or persons and the resulting costs incurred from the installation or use of these products. LincolnvsCadillac.com recognizes that "Cadillac" and "Chevrolet" and their respective logos, model names and numbers are registered trademarks of the General Motors Corporation. These and other terms used on this website are used for identification purposes only. Lincolnvscadillac.com is not affiliated in any way with the General Motors Corporation, Cadillac, Chevrolet, Mobil or any other website or company listed herein.