Search results for query: *

Still runs strong after 272K miles but wanting something with less problems for my daily driver. Picked up a CTS 2 door. Also bought a parts LS that I now have to figure out what to do with. Lol

Rust caused the pad material to separate from the backing plate. Notice the second pic.

Got it figured out. Corrosion between the rear sensor and mounting bracket. When it would get wet it would expand and push the sensor away from the tone wheel creating too much of an air gap. That was a tough one to figure out because it would act fine when dry. Lol

I'll start with the right rear. The pad material fell off the backing plate and found a bunch of metal shavings in the lip of the wheel. Found the pad material in my driveway. Lol

2000 V6. Just in the last few days the abs will kick on with light brake application but not when braking heavy. No abs light so this is an odd one for me

Needed to replace a lower ball joint but bearing was seized in the knuckle. Bought a parts car so stole the steering knuckle out of it and scored as the parts car knuckle had a new ball joint and unit bearing in it! Might as well replace the upper too.

I install a lot of aftermarket ball joints on Jeeps that have grease fittings on them. I wish I could get ones with grease fittings on them for the LS

Used a Snap On ball joint press

I pressed them in myself.

Just wanted to follow up on this. Turned out to be a bad lower ball joint. I had replaced this ball joint with a Moog one and it made the same creak as before so I was sure that it was not the sound. I got fed up with the noise and pierced the ball joint boot then lubed with lithium grease in a...

Got a front right suspension squeak/creak that is hard for me to pin down. 2000 V6. It makes a loud creak when hitting bumps or turning the steering wheel or even when braking and releasing the brakes. I have replaced the lower ball joint and the upper control arm/ball joint. Seems like when I...

My wife calls the parts car my LSs evil twin. Lol

I did the same thing. So far I have taken the Hydraulic fan solenoid, 4 lug nuts, and headlight out of the parts car. Went to take a front upper control arm off of it last night and found the ball joint was bad on it too. Lol. I figured when I take all the brake parts off of it, it will be...

Sweet, thank you!

Searched but could not find the torque spec. Thanks, Mike

Rehashing an old thread here. Have a 2000 V6 auto that needs front sway bar bushings. I measured the bar as 29mm. What the heck should I buy?

Added a light bar and tied it into the high beams with a relay. Wonder if you can do the same with the low beams.

Found a pic of when I changed out the door. Lol

220K. It has 241K on it now

Picked up a 02 v8 auto with a rod knock for $75. I have a 00 v6 auto. Just seeing what parts I can use from the bad car.