Search results for query: *

Instead of installing resistors that get really hot, I simply used t5 instrument cluster bulbs for each circuit, and since they don't get burning hot I tucked them in behind the trunk liner. They only pull 180ma's each, which is enough to fool the lamp out warning. I also didn't spend a lot of $...

The arm rest for the phone option is 2" longer and is thicker all the way around. You will notice in the pic's that the hinge is also different because the arm pad hangs over the rear vents.

If you would of noticed when they first started to crack, then the dust boots could of easily been replaced. At the stage yours are in they have already allowed dirt and moisture into the joint and should be replaced. When I noticed the first crack I replaced mine with the accordion style...

remote start If you just remove the modules(depending on what system you have), yes it is possible your car won't start. If you have the remote start only system, then you can remove the modules, because it only piggybacks the wiring to the ignition and starter. If you have the remote starter...

there is nothing with the remote start..... no need to rip everything out. There are two options when installing the Ford remote start (tach or tachless) the reason the wire is connected to the cop is for the tach.(the LS does not have a tach wire, it send the tach via the SCP data wires to the...

You said that you tested all the latches and they worked as designed (clicked twice & locked in both positions & did'nt release until you pulled the handle) & no door ajar warning when you manually closed them & wiggled the latch striker w/ a screwdriver, so why are you putting electrical tape...

door ajar switches First off, no amount of grease will make a difference to the ajar switch. The micro switch is at the top of the latch unit in a small pocket. It is sealed in epoxy with a rubber boot on the plunger that is only moved about 1/8" by the plastic latch striker. The latch has...

Door Latches I found some pic's of a passenger front door latch that I cleaned up to keep as a spare, it's a rather simple mechanism(no parts come flying out when you open it). I can't seem to get pic's to load here, so if you still want them, PM me w/ an email address. There's no way all 4...

The compressor they sent was from a V-6, the mounting points are longer on the V-6 than the V-8.

No, only the factory radio's can read the SCP data(for turning on the illumination, reverse signal, etc..). You will need to make your own connection for illumination.

The 16 pin connector only has 2 wires connected(gy/vt & bu/wh) they are listed as ACP A & ACP B(Audio Corporate Protocol), and are not used. The 6 pin connector has 2 wires connected(gy/bk & bu/ye) and are for the SCP + & SCP - data link.

The very 1st LS that I test drove in 1999 had a dead battery and the driver's door would'nt unlock with the key and I remember that the salesman had to crawl through the trunk to open the door. I was only going on what I saw, I personally have never had a dead battery in my 00 LS, but the key...

The driver's door will not unlock with a dead battery.... The key cylinder has a mechanical link to an electrical switch ONLY on the door latch, the electrical switch is wired to the driver's door module, which unlocks the driver's door and sends the signal to the REM for the 3 other doors...

Even if you have 2 working keys you can't erase the lost key. The dealership or locksmith will have to access the I/C with the NGS to erase all the stored keys.

06 LS options HID's and Nav/THX are not a package deal, the only options that can't be had individually are the folding mirrors (w/ auto dimming driver's side), wood trim, cargo net and the adjustable rear head restraints. You also have to have the heated/cooled front seats to get the rear...

You do not need a relay for the reverse signal... The REM puts out a 12 volt signal for the auto dimming rear view mirror at connector C420b pin#4 white/blue wire. You can also access connector C311 pin#8 white/blue wire that is on the passenger side roof pillar(behind the trim piece that the...

The ones with the slots are covers for the rear seat back latches and the others are covers for the seat track bolts.

With the way the cluster was designed for incandescent bulbs(diffusers to keep the straight on projection of the bulb from being brighter than the rest of the cluster) I don't think just replacing the (7) bulbs w/ LED's will give you an "even" color illumination. However, there is room between...

There is a total of (20) bulbs and (1) LED(airbag warning) in the cluster. If you are only wanting to change out the back lighting than you only need to replace (7).