dnsherrill
Dedicated LVC Member
---
this is from an ad on the local C/L...a 96 LSC, he's got it looking good, replaced that dirty white loom over the intake with _____?
---
changing plugs and wires..question
- Thread starter keVIIIn
- Start date
this is from an ad on the local C/L...a 96 LSC, he's got it looking good, replaced that dirty white loom over the intake with _____?
---
That engine bay looks pretty clean..is that the car with the cobra Rs?
dnsherrill
Dedicated LVC Member
yea, that guys posting it like every day....still at 38 obo....i don't need it
Sapperfire
Dedicated LVC Member
LoL @ that MAF install, doesn't look very- secure in the tube.
Gawd Gen1 engine bays are just terrible.
Lol I didn't even notice that, looks like a hunk of pvc thats attached with hose clamps to the maf. Whats so bad about 1st gen engine bays? Besides the plug wires there really isn't much difference in appearance (ya I know different intake and intake tube) I actually dont mind the sight of plug wires in the engine bay, reminds me that there's an engine there unlike cars of today that are just covered by a giant piece of plastic.
Markviiiedrea
Speed Bump
You should make your wires look nicer.
I did one wire at a time to keep from messing up the firing order and just routed them the same way they were before..I tried re-routing a few of them to make it look cleaner but some of the wires are just too long to start with.
Markviiiedrea
Speed Bump
Yhea, takes a little time, nicely run wires keep a few of the COP lovers off your back. 