cutouts for exhaust

[BlackMark8Li]

what do you guys think about this for the exhaust? I've been thinking about this for my exhaust when I get it custom this summer. for some reason I can't link to the exact page so the part # is DMH-20030-2


http://store.summitracing.com/

 

[98LSC32V]

I have dual cutoots on my car which has the stock dual LSC piping. They are after the front cats. When they are open I notice a big difference in top end power. Low end torque is slightly worse however. As for the sound they are loud....

 

[ImportEater]

i had a mustang with longtubes and i welded 2 angled pipes on the front of the h pipe and i welded 2 squares on the ends and i bolted throttlebodies to the squares, i attached bicycle cables to them and made a handle inside the car i loved it they didnt leak and they never warped or melted. all i ended up paying for was a $17 piece of tubing and the welding rods. everybody loved it and that is the only exhaust i ever plan to make for my mark

http://pg.photos.yahoo.com/ph/tito_benito2002/detail?.dir=d5ef&.dnm=d8bf.jpg&.src=ph

http://photos.yahoo.com/tito_benito2002

 

[94m5]

Cutouts.....Heh.



I've had nothing but bad luck with them. I ran them for about 2 weeks on my old 97 Z28. The leaks I got from them were horrible. I took it back to the shop, and had the entire system cutout and madrel 3" put in it's place.