Driver door panel coming out on top

[acetsid]

My driver door panel (95 M8) has been coming out on the top next to the window at the front...I can push it back in but it just keeps coming out. Is there a way to glue this back in or is it too deformed. It has been like this for a few years. Do I need to replace panel ?
Thanks for any help/suggestions.

 

[1wykdmk8]

My driver door panel (95 M8) has been coming out on the top next to the window at the front...I can push it back in but it just keeps coming out. Is there a way to glue this back in or is it too deformed. It has been like this for a few years. Do I need to replace panel ?
Thanks for any help/suggestions.

Go to the local parts store and pick up some stuff called Trim Adhesive by 3M. Take the door panel off, and pull back the part that is not sticking and spray the adhesive on both the panel, and the material that is not sticking. Give it some time to set up (being that is cold out), or take a hair dryer to both parts to speed up the adhesion factor. To check, the glue should be sticky to the touch, but not wet. The stickier the better....do not allow it to fully set up (not sticky at all) and then push the material back to where it belongs and then take and use some clamps to hold the panel in position. Let sit overnight, and replace the panel the next day.

Hope that helps.

 

[67Continental]

thanks for the tip, mine is doing the same thing.

 

[1wykdmk8]

:slap: