F/S 03 black anodized cobra rims

danny_holtermann

danny_holtermann

Dedicated LVC Member
Joined
Nov 4, 2007
Messages
1,957
Reaction score
0
Location
Green Bay
Contact seller
I have a set of new, never mounted, only two have even been taken out of the boxes black anodized cobra rims. They are 17 X 9 with a 26mm offset. these will not fit on the marks, i learned my lesson....Damn
I am willing to trade these for black rims with the right offset of 40mm, Or to sell them for 850. I would rather a pickup, or i could bring them to the beach party. I will however ship them, but you will have to pay whatever shipping costs. PM me for any offers

P10112401.jpg
 
why will they not fit a mark I thought the mark offset was 36mm the difference would only put the wheel out 1cm farther than the current wheels and in my opinion the stock wheels are in to far anyway and with going with a wider rim by 2" you will probably need that clearance on the inside
o and the wheels are sexy need better pics
 
Either way, whether it sticks out too far, or sits in too far. You could have the center milled a little bit & be right where you need to be. Unless you're scraping on the inside. And then there's spacers. If these are the mustang bolt pattern i'm sure someone makes hub-centric spacers for them. Just my .02
 
The offset is not great but it will fit the problem is the bolt pattern. mustangs and marks do NOT have the same bolt pattern so if those wheels were sold for mustangs the the bolt patten will not work i Think the mustang bolt pattern is 5x4.5 and the mark's pattern is 5x4.25. i am sure somone will correct me if i am wrong.
 
They will be 1cm towards the outside of the car from where they should be... They'll definitely fit fine, and I bet they'll look fine too. Hang onto them and give it a try (frankly at that price you'll probably hang onto them anyway :p )
 
You must log in or register to reply here.

Members online

Total: 102 (members: 1, guests: 101)
Back
Top