F/S 3.73 ring and pinion and trac-loc
- Thread starter BlackIceLSC
- Start date
Grrrr - where were you 2 weeks ago 
BlackIceLSC
Dedicated LVC Member
Joeychgo said:Grrrr - where were you 2 weeks ago
sitting at home, wondering if i should install these....
BlackIceLSC said:
Of course you should.
BlackIceLSC
Dedicated LVC Member
nah...I'll sell them, and put the funds towards our race car instead. Translation?- priorities kicked in.
JoshMcMadMac
Dedicated LVC Member
How much are you looking to get for it?
hotrodlincoln93
Well-Known LVC Member
yea how much? email me chadsfury@aol.com
BlackIceLSC
Dedicated LVC Member
I am "looking to get" whatever I can....if i ask too much, you guys will balk...if I ask too little, I will lose...
email me some offers folks before these go on the auction site Hell, I might just build the spare case I have and make a FRPP set up that used to available....but I'd rather sell them the way they are instead of trying to move a 70lb case.
...if you make an offer like the guy who asked "$80 shipped"...well...I wont even reply.
Ford trac-loc, 28 spline, and a new ring and pinion....you guys know what they're worth...make an offer.
email me some offers folks before these go on the auction site Hell, I might just build the spare case I have and make a FRPP set up that used to available....but I'd rather sell them the way they are instead of trying to move a 70lb case.
...if you make an offer like the guy who asked "$80 shipped"...well...I wont even reply.
Ford trac-loc, 28 spline, and a new ring and pinion....you guys know what they're worth...make an offer.
BlackIceLSC
Dedicated LVC Member
multiple emails....quite a few offers...some very close...
$275 takes them both + freight.
$275 takes them both + freight.
BlackIceLSC
Dedicated LVC Member
ok...nothing sold as of yet...too many 'tire kickers'.
I get a lot of requests to have these assembled in to my spare center section and completely set up as a single, bolt-in unit.
who would be interested in that set up? basically a FRPP clone 3.73/trac-loc unit...
if you guys would rather see that, then you need to make me some offers on that set up to see if it's worth my time. otherwise I might have to slap these in my car and THAT will cost me some gas mileage, and rear tire life!!!
I get a lot of requests to have these assembled in to my spare center section and completely set up as a single, bolt-in unit.
who would be interested in that set up? basically a FRPP clone 3.73/trac-loc unit...
if you guys would rather see that, then you need to make me some offers on that set up to see if it's worth my time. otherwise I might have to slap these in my car and THAT will cost me some gas mileage, and rear tire life!!!