Sunroof stuck open

T

turn_on68

Dedicated LVC Member
Joined
Sep 15, 2004
Messages
920
Reaction score
4
Location
New Braunfels, Texas
Sunroof stuck open. It almost is closed. It is just short of closing all the way. Anyone have any ideas on it. It also quits sliding right before closing then you press the buton again and it goes in but does not rise up all the way shut. Also on opening it quits after one inch and when you press the button again it then opens all the way. Also the pop up part of the roof switch will not activate.
 
my Mark doesn't have a sunroof, sorry I can't help you, but this is one of the reasons I didn't want one, they seem to have alot of problems and I would not be happy if I couldn't close a hole in my roof. good luck, JC....
 
dont know about ASC, but the motor is def. out of sync when you push the open button and it goes back an inch the motor thinks that the roof is vented so it goes a little bit to "close" possion press it again and it opens the rest of the way, i would try to close it as far as it will go then take the motor down and press the close button and the motor will run till it gets to a "stop" leave the motor off the track and shut the roof then re install the motor
 
I found all the motor screws loose that hold the motor in place. I also found I could put the torque bit into the center hole in the motor and manually close the roof. I did what you said, and it still has that first click stop. It does however run the top into place, it just won't go that extra step and vent the roof. I am going to get some lock washers to put on the screws.
 
lock wasers and locktite are a good thing and here is the instructions out of the book and now i know too i told you the generic way (i do all the sunroof concerns that come into work) this should do it for ya
SECTION 501-17: Sliding Roof Panel 1998 Mark VIII Workshop Manual
GENERAL PROCEDURES Procedure revision date: 03/15/1998

--------------------------------------------------------------------------------

Motor Synchronization
Operate the roof opening glass to the flush position.
Remove the roof headlining access hole cover (52076).

NOTE: The ground wire must be installed in the same position on installation.

Remove the screws and the roof sliding panel motor. Do not disconnect the connector.

Operate the roof sliding panel switch (15B691) until the roof sliding panel motor is shut off by the micro switch.
NOTE: Timing tabs are located in the window on the roof sliding panel motor.

Check that the white and gray timing tabs are aligned in the window.

If the motor is not synchronized, adjust as follows:
If it is disconnected, connect the battery ground cable (14301).
Connect the sliding roof panel motor wiring connector to roof panel wiring connector.
Operate the roof sliding panel switch advance the sliding roof panel motor drive gear until the white timing tab on the gear and the gray timing tab on the motor are aligned.
Disconnect the sliding roof panel motor wiring connector from the roof panel wiring connector.
From the retracted position, crank the roof sliding outer glass panel (502A82) flush with the roof.
CAUTION: The sliding roof panel motor (15790) must be installed carefully straight up into position. Installing the sliding roof panel motor at an angle may damage the motor mechanism.

Install the sliding roof panel motor; refer to Opening Shield—Roof Sliding Panel in this section.

Install the roof headlining access hole cover.


--------------------------------------------------------------------------------
 
Nice. Is it the same for 96? My has been acting funny for a while, although I have always been able to get it to close so far.
 
02LSE96LSC91SE84TC said:
Nice. Is it the same for 96? My has been acting funny for a while, although I have always been able to get it to close so far.
Click to expand...
no u r very diff, shoot me a pm of your email there are some pics and they and they wont post here
 
You must log in or register to reply here.

Members online

Total: 139 (members: 1, guests: 138)
Back
Top