Search results for query: *

Have you try this aluminum degas reservoir, looks good.

Well I decided to fix some issues, like replace water pump, tensioner, pulleys, belt, all new plastic thermostat parts. Fab an aluminum upper rad hose Y pipe, replacing the weak plastic oem one. Full coolant flush and add all new oem recommended motorcarft coolant. The transmission solenoid pack...

I just fab mine after replacing this a couple times, made it out of aluminum tubing with flared ends to support the hosing and clamps to hold a seal. Now with all the heat cycles over time it will not crack. I'll take a pic later of it.

I have to same problem with the rod that connects to a flap for the cabin air filter has broken in my 06. It seem to be a common problem with the plastic bracket which is one piece part of the flap, over time breaks. I haven't had time to address the issue yet on my car.

Your pervious issues was the same problems I had. I replace oem coils, throttle body, egr / map sensor, tps and so on. Sent my pcm out for repair and it correct my problem. As for an firmware update you would have to visit your local ford / lincoln dealer to reflash your pcm. Hopefully you will...

Great doing business with you, fast shipping. A++

How much for the complete throttle body?

Yes the Gen 2 has a shorter and simpler setup as for an intake design goes. I started making one today to test out at some point on my 06 Gen 2 V8 on my dyno to get a comparison from factory intake to this setup as a straight bolt on without and with pcm tuning. At some point I'll make a box...

Thanks for your reply, yes I've alway used Motorcraft coil giving the fact about RF issue that are known. I've have not change the spark plugs yet this year giving the fact that I don't drive it much. So this weekend I'll change to motorcraft spark plugs and gap them to the recommend clearance...

Hello everyone, I'm hoping someone could shine some light on my issue with my 06 V8 LS. I've been threw the forum and still can't find a solution. I've been threw a lot of issue and fixing with this car from a complete heater core change to DCCV, thermostat, all plastic housing for the...

You may want to pressure test the system for any leaks / cracks in your coolant system that will cause overheating issue. This will save a lot of time as well if issue continues. I was in the same situation as you and found a lot of leaks including the heater core which wasn't fun to replace.