So slim pickins at the U pull it place. A single FN10, a 93. It has aluminum driveshaft, I am hopefully going to be able to pull it (I am not sure if it is single piece or not, I forgot to check...darn). I have a pretty serious vibration when accelerating up to and over interstate speeds, but pretty smooth when cruising at those same speeds. Does my 97 have a steel or two piece aluminum shaft?
Will the wiper tray/cowl from it work on my 97? How about the defroster grille (piece on top of dash)? I have quite a few Continentals to pick a drivers exterior door handle from (none in Silver Frost, but at this point I want fully functional over praying I can get in). Also the wipers on my car are horrible, I have put on new blades and they both skitter across, even blades that work fine on other vehicles, so possibly the arms are bent, probably pick those up too.
I am trying to get my 89 Cougar back on the road so I can spend more time working on my 97 Mark, I can't more than a couple hours into it at a time due to needing to use it and no backup (89 Cougar and head gaskets, of course).
Will the wiper tray/cowl from it work on my 97? How about the defroster grille (piece on top of dash)? I have quite a few Continentals to pick a drivers exterior door handle from (none in Silver Frost, but at this point I want fully functional over praying I can get in). Also the wipers on my car are horrible, I have put on new blades and they both skitter across, even blades that work fine on other vehicles, so possibly the arms are bent, probably pick those up too.
I am trying to get my 89 Cougar back on the road so I can spend more time working on my 97 Mark, I can't more than a couple hours into it at a time due to needing to use it and no backup (89 Cougar and head gaskets, of course).