Engine Parts 3.9L DOHC

B

BogusSVO

LVC Member
Joined
May 19, 2009
Messages
32
Reaction score
0
Location
pensacola
Contact seller
I have three 3.9l DOHC Engines that are being pulled apart.
The excat years/mileage is Unknown.
The engines were pulled and replaced due to Knocking in the bottom end, one block has a window in it
Pics can/will be provided upon request

I am keeping the heads to rebuild(thats what I do) Everything else is up

Coils, $15 ea
V/C $10 ea
Throttle Body $10 ea (if it has sensors on it, you'll get them too)
Oil Pan $20
Intake $20
Time Chain cover $20
T-stat housing $5
Rod/piston $20 ea (if you need a set deals will be made)
Block w/bed plate $200 Obo
Crank (if any are good) $50
Fuel Injectors $10 ea

Heads, Pair $550 (no Core charge)
Head, single $325 (no Core charge)
Head work will be full tear down, pressure check, 3angle Valve job, New Viton stem seal, Lash set, Springs checked, guides checked , resurfaced on CBN Hi-speed mill)


If there are any other parts, just ask

I ship MOST items by USPS Priorty Mail, shipping will be at cost
I ship alot of flat rate boxes, small is $5 large box is $10
If you pay by Paypal (I perfer it) I print most shipping lables through paypal.

I know I am not known on this board, feel free to ask any questions.
Land Line # 850 432 2603

To the MODS: If you will provide a PP addy, I will donate 10% of any sale to your board.
 
BogusSVO said:
Head work will be full tear down, pressure check, 3angle Valve job, New Viton stem seal, Lash set, Springs checked, guides checked , resurfaced on CBN Hi-speed mill)
Click to expand...


Doesnt sound like PnP work to me?

Can you send me pictures of the intake manifold(s), Ive been trying to get ahold of a Gen2 intake manifold forever.
 
Missing Linc' said:
Doesnt sound like PnP work to me?

Can you send me pictures of the intake manifold(s), Ive been trying to get ahold of a Gen2 intake manifold forever.
Click to expand...

Well if he starts doing PnP work I'm sure he can make a good amount of cash, especially with the limited aftermarket on these cars.
 
These heads dont need to be ported out, polishing them to get rid of some casting flaws would be alright but they flow plenty, spend your money elsewhere..
 
Missing Linc' said:
Doesnt sound like PnP work to me?

Can you send me pictures of the intake manifold(s), Ive been trying to get ahold of a Gen2 intake manifold forever.
Click to expand...

I didn't think so either, but when I hear "3 angle valve job", well, I figure it's better to ask. I'm definitely TRYING to spend my money elsewhere, just need one more person to get that going on.
 
I am/was going to just build them as stock replacements. But if you want a basic gasket match w/ runner and bowl clean up , or a full out PnP with Flow bench work I can do that.

Flow work will be done on a SuperFlow 600 w/flow com
 
the 2 I have tore down as of now have date codes of Feb 2000 and Jan 1999
I have some parts left from some others still floating about, the build dates I am not sure of at this time
 
You must log in or register to reply here.

Members online

Total: 220 (members: 2, guests: 218)
Back
Top