Right on the Mark
Dedicated LVC Member
I searched all 3 posts and no one says where they got theirs from. Any info on where to call? All peeps would say was it was in Ohio. Thanks Frank
Info on where to buy V6 5sp FLYWHEEL ??
- Thread starter Right on the Mark
- Start date
Right on the Mark
Dedicated LVC Member
Ford no longer makes the flywheel. So I don't think maxx can help.
cammerfe
Dedicated LVC Member
Aftermarket manufacturers may be your best bet. Some years ago, I did a hybrid 2300 Ford four to a Doug Nash 5-speed. This necessitated both a modified Lakewood scattershield, and also a flywheel that attached to the four cylinder crank and took a clutch intended for a Boss 302 V-8. All it took was a call to McLeod to get the flywheel. And it cost the same amount as a catalog item. Good Luck!
KS
KS
Mechanicboy
Dedicated LVC Member
I bought mine from a jag supplier overseas. If you want I can see if they have more. PM me your address and I'll try to get a cost for you.
craigh
Dedicated LVC Member
This was on another post but it is a 5 speed that a guy is parting out.
http://toronto.en.craigslist.ca/tor/cto/1686157218.html
http://toronto.en.craigslist.ca/tor/cto/1686157218.html
went to go check it out the car this morning, car is in bad shape rust wholes in the frame just terrible the bracket I'm looking for was on his car it almost disintegrated in my hands as i felt it. I can ask him for you but yeah...
Mechanicboy
Dedicated LVC Member
How much?
If you want a used one I could sell you my used one. It's probably in the same condition or better then that one that guy is parting out.
Mechanicboy
Dedicated LVC Member
I found it, $735.15.
Wow, I'm going to do mine for less then half that. Labor blows, that's why I do it myself.
Just an FYI, I bought a Sacks clutch kit. The parts are identical to the Luk that came out, in fact the pressure plate says Luk on it. They didn't ship it with a alignment tool but I had them send me one at no extra charge.
Wow, I'm going to do mine for less then half that. Labor blows, that's why I do it myself.
Just an FYI, I bought a Sacks clutch kit. The parts are identical to the Luk that came out, in fact the pressure plate says Luk on it. They didn't ship it with a alignment tool but I had them send me one at no extra charge.