So I picked up this 03 with a 3.9 motor 82K miles from the auction real cheap! Saw its in limp mode, looked it up real quick and I saw miss fires, thought I could just replace the coils, plugs and valve cover because it was leaking to the outside like crazy! so I bought 8 coils and valve cover gasket! so while I was pulling the coils I was expecting oil! shockingly there was no oil at all, I went ahead and replaced the coils, car ran the same, didn't change a bit! codes I had were
P0353
P0356
P0357
P0358
Also
P2107 Throttle actuator control model processor
P2110 Throttle actuator control system forced limited rpm
I went a head and bought a used one and replaced it! car was the same and didn't change at all!
Next I started checking compression, all was around 120 but number 7 was 0 and 40 WITH the car running! and the car finally started smoking blue smoke a lot of it!
I went a head and bought a new motor with 40 K miles on and replaced it, installed the new coils, NOW car ran like **** with the same code! now I checked injector pulse and there was none in Cylinders 3 56 whats stopping the injectors ? computer ? any advice ? please ?
P0353
P0356
P0357
P0358
Also
P2107 Throttle actuator control model processor
P2110 Throttle actuator control system forced limited rpm
I went a head and bought a used one and replaced it! car was the same and didn't change at all!
Next I started checking compression, all was around 120 but number 7 was 0 and 40 WITH the car running! and the car finally started smoking blue smoke a lot of it!
I went a head and bought a new motor with 40 K miles on and replaced it, installed the new coils, NOW car ran like **** with the same code! now I checked injector pulse and there was none in Cylinders 3 56 whats stopping the injectors ? computer ? any advice ? please ?