With 3.73's it starts to hum at 100 and then you can feel the vibration in the floor at 105. I will try indexing it this weekend and see if I can make it better, if not then I will get a Dennys or something. I can resell the shaft for $100 and the balence would be close to $100 plus they would need it for at least 2 days and thats another $110+ for a rental car. For a little more I can have something thats better and doesnt put me behind the wheel of a POS BG car for a couple days.
Dont know, Superman did the install. It was dark and after 1am and we had already worked 15 hours by the time it was bolted in.
Know how I knows you is teh ghey?
Finished my front suspension. What a major PITA. My fault though, I opted for the parts from SCP instead of getting made in USA MOOGS!
The sway bar ends links had to much taper and would not pull up into the knuckle or sway bar end. Bill said "Torque them to spec and be done with it." Yeah right, still 3/16 -1/4" of stud showing on the ball end after torquing. Bought TRW end links today and fit like a glove.
Torqued rest of the Tiwan crap and then noticed the boot on driver LCA is loose, not gonna hold grease and will let water in. Boot on pass LCA twists every time I turn the wheel so it will rip soon and be worthless as well.
Nobody twisted my arm to buy the parts so it's all on me. Start saving money to by the good parts and get ready to do this again.
End of rant
Know how I knows you is teh ghey?
Wow, I really hate hearing that. I just replaced my entire front end with SCP parts. It didnt take long and its not that hard but I hate paying for alignments.
.
I thought you were older and wiser
. Tonigght I parked mine under the front porch and covered her with three old comforters. Storms are comin and I'm scared. I'm gonna build a carport I don't care if I rent.
