What did you do to your Mark VIII today?

[Big Mike]

Got a new camera, so I'm gonna take some good pics one day after I hit the car wash next.

Re-rigged my ghetto intake tube repair until I get a new plastic tube, clamps, fittings, and airbox.

 

[My Great 8]

Installed my CE steering wheel. My interior is complete!

 

[thaywood]

^^^ Dat's ghetto Dawg...

Yeah. I know. But it was the only one I could find on fleabay on short notice. If it had been the p/s, I could have waited. I'll paint it before long anyway

 

[Raped Ape]

Went to JY and found a new coil conversion setup. Put it on the car today to see if I like it or not, will decide next week if I like it or not, and may switch back to my air ride. New sway bar bushings, and new rear SensaTrac shocks also.

 

[Gilby959798]

put full coverage back on it...

 

[Big Mike]

Refined my ghetto-fixed intake tube and airbox. We shall see if it holds this time.

 

[BAD97LSC]

got my new rear pumpkin with tracloc and 4:30's. now i just have to get it in the car, as soon as brandon gets my damn computer here!!!!!!!!!!!!!!!!!!!!

 

[Big Mike]

Jamie, is the old stuff still spoken for?

 

[BAD97LSC]

yup.

 

[Sapperfire]

Washed it

 

[Sapperfire]

Drove it to see....

Korn!

And Disturbed!

 

[mespock]

I cleared snow and moved my 94 so I could finish clearing the driveway where I have it parked.

 

[chris2523]

hit 178000 miles.

 

[Sapperfire]

Took the Super Bass ProBox out of the 93, tossed in a single 10 MTX in a sealed box..much quieter..and it "lifted" the car about 1/2" in the rear, lol

 

[chris2523]

how do you have room for a backseat? Lol.

 

[Sapperfire]

The box was in the trunk. Just had to cut the X-brace out from behind the seat, then bend the metal upward, shove box in, bend metal down,replace seat

 

[BAD97LSC]

why not build something to fit that doesnt require cutting parts of your car off!!

 

[Big Mike]

The coolest stuff requires MODS!

 

[LaserSVT]

why not build something to fit that doesnt require cutting parts of your car off!!

Yeah, thats why it was pulled out in favor of a single 10" small box. In the new car hes installing my old G5 10" when the new cone shows up. Hes learning.

 

[Mark8Murder]

Got my new Black Saleens in, Installed them on the Midnight Gray Mark, decided against the sensor lower and will be ordering an ASHAM8 Module..... I will post pics when it no longer looks like a 4x4

....Love the Black Saleens, think I'm getting a set for the Black Mark

 

[Sapperfire]

why not build something to fit that doesnt require cutting parts of your car off!!

I treat it like a virgin...just ram and tear till it fits

 

[Big Mike]

Got my new Black Saleens in, Installed them on the Midnight Gray Mark, decided against the sensor lower and will be ordering an ASHAM8 Module..... I will post pics when it no longer looks like a 4x4

....Love the Black Saleens, think I'm getting a set for the Black Mark

IMHO chrome rims like the ones on the black mark would look better on dark gray, black would make it seem muted. Either way though, if you HAVE to get Saleens, black is the way to go!

 

[Mark8Murder]

IMHO chrome rims like the ones on the black mark would look better on dark gray, black would make it seem muted. Either way though, if you HAVE to get Saleens, black is the way to go!

Hey! Thanks!

 

[BAD97LSC]

I treat it like a virgin...just ram and tear till it fits

i hope you dont treat your new one that same way.

 

[LaserSVT]

i hope you dont treat your new one that same way.

He wont. I would punish him. Hes been kinda lazy to get it over here so I can pull the blend door actuator out and epoxy it though.


All I did to mine today was throw $25 in its tank and then listed it on ebay for sale.